NEC 120Mf, 5800 manual Troubleshooting, POST Error Message List, Chapter

Chapter 4

Troubleshooting

If your NEC Express server does not operate as expected, read this chapter before assuming a failure.

NOTE: Troubleshooting and POST error messages refer to

User Guides.

POST Error Message List

On-screen error message		Description	Cause	Action
0200	Failure Fixed Disk	Hard disk failure	1. Incorrect setting in	1.	Check parameters
			Setup	entered in Setup
			2. HDD failed	2.	Replace HDD
			3. Motherboard failed	3.	Replace Motherboard
0210	Stuck Key	Keyboard connection	Poor keyboard	1. Disconnect and reconnect
		error	connection		keyboard.
				2.	Replace keyboard
				3.	Replace Motherboard
0211	Keyboard error	Keyboard error	Keybord failed	Check connection
0212	Keyboard controller	Keyboard controller	Keybord controller	1.	Check connection
	Failed	failure	failed	2.	Re-Start
				3.	Replace Mother Board
0213	Keyboard locked -	Keyboard is locked.	Keyboard is locked.	Release Keyboard lock
	Unlock key switch
0220	Monitor type does not	The monitor type is not	Incorrect monitor type	1.	Reset default values in
	match CMOS - Run	consistent with the	setting		Setup.
	SETUP	CMOS data.		2. Clear CMOS
0230	System RAM Failed	System RAM error.	DIMM failed	1. Replace DIMM
	at offset			2.	Replace Motherboard
0231	Shadow Ram Failed at	Shadow RAM error.
	offset
0232	Extended RAM Failed	Extended RAM error.
	at address line
0250	System battery is dead	The system battery is	NV-RAM battery	Replace Motherboard
	- Replace and run	worn out.
	SETUP
0251	System CMOS	The system CMOS	NVRAM failed	1. Reset Setup parameters
	checksum bad -	checksum is incorrect.		2.	Replace Motherboard
	Default configuration
	used
0252	Password checksum	The checksum of a	Password cleared	Reset Setup parameters
	bad - Passwords	password is inaccurate.
	cleared
0260	System timer error	A system timer error		Replace Motherboard
0270	Real time clock error	A real-time clock error	RTC failed