Removing the LCD Module, Removing the Coil | NEC M320 guide

Removing the LCD Module

Removing the LCD Module

To remove LCD Module remove the keyboard (see Removing the keyboard), remove the CPU (see Removing the CPU) , then perform the following steps:

1.Remove the wireless LAN antenna coil from the wires and disconnect the Lid Switch Connection as shown in Fig. 22

Fig. 22 Removing the Coil

2. Release screws on the bottom and rear of the base unit as shown in Fig. 23

Fig. 23 Removing the LCD hinges screws

3. Release the plastic hinge covers (left and right) from the base unit as shown in Fig. 24

Coil

A = M2.5x7 Silver

B = M2.5x5 Silver

NEC Versa M320 Disassembly Manual

Page 14

Image 14

NEC manual Removing the LCD Module, NEC Versa M320 Disassembly Manual, Removing the Coil, Removing the LCD hinges screws

Contents

Versa M320 Disassembly Manual Table of contents NEC Versa M320 Disassembly Manual Overview Disassembly InstructionsReassembly Instructions Technician Notes Avoid Electrostatic Discharge Power Supply UnitHazardous Voltage AVERTISSEMENT Removing the Battery Removing the Hard Disk Drive Removing the Memory Module Removing the Wireless LAN & MDC Modem Module Removing the Keyboard Fig. 11 Releasing the optical drive Removing the optical disk driveFig. 10 Removing the keyboard flat cable Fig. 12 Removing the optical drive Removing the CPU Fig. 14 Removing the heat plate 4. Lift up the LED board as shown in Fig M2x10 Silver Fig. 18 Lifting up the CPU fanFig. 19 Releasing the CPU Heat Sink Fig. 20 Removing the heat sink Fig. 21 Releasing the CPU Fig. 23 Removing the LCD hinges screws Removing the LCD ModuleFig. 22 Removing the Coil Fig. 24 Releasing the plastic hinge covers Fig. 25 Lifting up the LCD module Disassembling the LCD Panel 4. Unscrew all screws encircled in Fig Fig. 31 Removing the LCD Panel hinges Removing the Top CoverFig. 32 Removing Wireless Antenna A = M2x4.5 Silver Fig. 33 Removing the top cover screwsA = M2.5x7 Silver B = M2x4.5 Silver M2.5x7 Silver Fig. 35 Removing the top cover Removing the Touch PadFig. 36 Touch Pad Assembly Fig. 38 Lifting up the FDD Removing the Floppy Disk DriveFig. 37 Removing the FDD Fig. 40 Removing the audio front panel Removing the Audio BoardFig. 39 Audio Board screws and speakers connector Fig. 43 Removing the HDD flat cable connector Removing the Main BoardFig. 42 Removing the RTC Battery Fig. 41 Lifting the Audio Board A = M2.5x5 Silver B = M2x4 Silver Fig. 44 Removing the main board screwsFig. 45 Remove the spacers on the I/O panel C = M2.5x5 Silver D = M5x6 Silver Fig. 47 Screw at Audio Board Holder Removing the speakersFig. 46 Removing Main Board Description DIP Switch SettingDip Switch Seeting Screws Versa M320 Disassembly Manual