5 T R O U B L E S H O O T I N G
This section helps you resolve problems you may encounter while setting up or using your MultiSync MT1020G/820G LCD
Projector.
Status Light Messages
Condition | Status | |
|
| |
OFF | Normal | |
|
| |
On Continually | The projector lamp has exceeded 2000 hours of operation and should be replaced. | |
|
| |
Blinking Very Rapidly (On and off | Either the lamp cover or filter panel is not fastened properly. Check each and | |
in a cycle of 1 sec.) | reattach them if necessary. | |
|
| |
Blinking Rapidly | The projector is overheated. | |
(On and off in a cycle of 4 sec.) | • | If there is insufficient ventilation around the projector or if the room where you're |
|
| presenting is particularly warm, move the projector to a cooler location. |
| • | Check the filter and clean it if necessary. |
| • | If the problem persists, contact your NEC dealer for service. |
|
| |
Blinking Slowly (On and off in a | The cooling fan has stopped. Contact your NEC dealer for service. | |
cycle of 8 sec.) |
|
|
|
| |
Blinking Very Slowly (On and off in | The lamp is not turned on. | |
a cycle of 12 sec.) | • | The projector was turned off and back on too quickly. Turn off the projector, wait |
|
| one minute, then turn the projector back on. Or the lamp is burnt. |
|
|
|
E – 30
