Default symbol is C | NEC SP5008A specification

The default symbol is C.

1.Press the “Apply” button (at the bottom) after you finish to save changes.

2.Press the “Reboot” button to apply the changes.

31

Image 32

NEC SP5008A user manual Default symbol is C

Contents

IP Telephony Gateway Online Upgrade Table of Content Web AdministrationIntroduction Startup Specification Operation Key Features Introduction LED Indicators Physical DescriptionSP5058A SP5018A SP5008A T1-T8L1-L8 T1/P1-T4/P4 Login into the System StartupPage Network Configuration WAN Setting Dhcp Enable/Disable this option Static IP Dhcp PPPoE LAN Setting Description Description General configuration Pabx Mode SP5018A onlySIP Setting Pabx Connection Primary FXS SIP settings FXO Dialing Prefix SIP Setting Password AccountNumber Display name SIP Advanced Setting Make sure your proxy server or soft switch Supports the feature, if the proxy does not supportIt and you enable this feature, all IP outgoing calls Feature is for FXS only Payload Type Setting Page Line Setting Enable Hotline No Answer Forward Time FXS onlyLine1~Line8 relevant data Type RegPage Qos Setting Differentiated Services Code Point Setting DscpDscp Signal ToS Setting ToS RTP Speed Dial Editor Speed Dial SettingSpeed Dial Peer to Peer call Speed Dial Editor In P2P application Caller ID Setting Caller ID Setting Line 1~LineDtmf Caller ID Start Symbol Dtmf Caller ID End Symbol Default symbol is C CDR Setting CDR mode CDR Server address CDR Server portPage Syslog Setting Syslog mode Syslog Server address Syslog Server portPage Advanced Configuration System settingPage Page Ping ip to keep alive network Ping timersec Sntp Setting Codec Setting Codec PriorityCodec Packet Size Bandwidth Required Voice Setting You can set this option for each of the 8 lines Tone Setting Disconnect tone Phone Setting Min. Digit Count Country Digit Manipulation FXO Dial Prefix Third Example Dial PlanDial Plan Editor Page Management Provision Server Save-Reload setting Export File Import File Upgrade Firmware Updating the firmware by FTP Updating the firmware by Tftp Updating the firmware by Http Reset to Default Network Status Displays the MAC address of the WAN port Boot version Version InfoPost version Application version Register Proxy Port StatusPort Type Password Current passwordNew password Confirm new password Rebooting the system Enable the representative line Peer to Peer mode FXO to FXSConfiguration All the line and Disable all the register Enable the representative line Line 1~Line 8 Side B Peer to Peer mode FXS to FXS Page Page Page Specification SP5018A SP5058A Networking