Network Configuration | NEC SP5008A manual

2.2 Network Configuration

By default, the gateway is in NAT mode (router mode) and can share Internet access with PCs. Go to [ Network Configuration / WAN Setting ], and configure WAN setting according to actual condition. In default IP type of DHCP client, it requests necessary IP information from your ISP automatically.

-----------------------------------------------------------------------------------------------------

Note:

1.Different ISPs require different methods of connecting to the Internet. Please consult your ISP to select right IP type (Fixed IP, PPPoE) of WAN.

2.You can retrieve the IP address of the WAN port by keying #126# on the phone set that is connected to the FXS port of the gateway. You will hear an IVR announcing the current IP address of the WAN port.

-----------------------------------------------------------------------------------------------------

9

Image 10

NEC SP5008A user manual Network Configuration

Contents

IP Telephony Gateway Online Upgrade Introduction Table of ContentWeb Administration Startup Specification Operation Key Features Introduction SP5058A LED IndicatorsPhysical Description SP5018A L1-L8 SP5008AT1-T8 T1/P1-T4/P4 Login into the System StartupPage Network Configuration WAN Setting Dhcp Enable/Disable this option Static IP Dhcp PPPoE LAN Setting Description Description SIP Setting General configurationPabx Mode SP5018A only Pabx Connection Primary FXS SIP settings FXO Dialing Prefix SIP Setting Number PasswordAccount Display name SIP Advanced Setting It and you enable this feature, all IP outgoing calls Make sure your proxy server or soft switchSupports the feature, if the proxy does not support Feature is for FXS only Payload Type Setting Page Line Setting Line1~Line8 relevant data Type Enable HotlineNo Answer Forward Time FXS only RegPage Dscp Signal Qos SettingDifferentiated Services Code Point Setting Dscp ToS Setting ToS RTP Speed Dial Speed Dial SettingSpeed Dial Editor Peer to Peer call Speed Dial Editor In P2P application Dtmf Caller ID Start Symbol Caller ID SettingCaller ID Setting Line 1~Line Dtmf Caller ID End Symbol Default symbol is C CDR Setting CDR mode CDR Server address CDR Server portPage Syslog Setting Syslog mode Syslog Server address Syslog Server portPage Advanced Configuration System settingPage Page Ping ip to keep alive network Ping timersec Sntp Setting Codec Packet Size Codec SettingCodec Priority Bandwidth Required Voice Setting You can set this option for each of the 8 lines Tone Setting Disconnect tone Phone Setting Min. Digit Count Country Digit Manipulation FXO Dial Prefix Dial Plan Editor Dial PlanThird Example Page Management Provision Server Save-Reload setting Export File Import File Upgrade Firmware Updating the firmware by FTP Updating the firmware by Tftp Updating the firmware by Http Reset to Default Network Status Displays the MAC address of the WAN port Post version Boot versionVersion Info Application version Port Type Port StatusRegister Proxy New password PasswordCurrent password Confirm new password Rebooting the system Configuration Peer to Peer mode FXO to FXSEnable the representative line All the line and Disable all the register Enable the representative line Line 1~Line 8 Side B Peer to Peer mode FXS to FXS Page Page Page Specification SP5018A SP5058A Networking