Peer to Peer mode FXO to FXS, Configuration | NEC SP5008A manual

4.Operation

4.1Peer to Peer mode (FXO to FXS)

In this application, the distance of PABX extension is not limited. You can use the same PABX in two or more branches.

Configuration:

1.Side A (FXO): IP address: 10.1.1.2, number is 2000 to 2008

2.Side B (FXS): IP address: 10.1.1.3, number is 1000 to 1008

Side A : (SP5058A: IP address 10.1.1.2)

General Configuration / SIP Setting

Primary proxy/P2P IP (Side A--FXO)

Call number configuration

Representative number (Side A -- FXO)

Specify the destination (Side B) IP Address of Peer to Peer mode, and specify the port# with 5076.

Enable the representative line

64

Image 65

NEC SP5008A user manual Peer to Peer mode FXO to FXS, Configuration, Enable the representative line

Contents

IP Telephony Gateway Online Upgrade Web Administration Table of ContentIntroduction Startup Operation Specification Introduction Key Features Physical Description LED IndicatorsSP5058A SP5018A T1-T8 SP5008AL1-L8 T1/P1-T4/P4 Startup Login into the SystemPage Network Configuration Dhcp WAN Setting Static IP Enable/Disable this option Dhcp PPPoE Description LAN Setting Description Pabx Mode SP5018A only General configurationSIP Setting Pabx Connection FXO Dialing Prefix Primary FXS SIP settings SIP Setting Account PasswordNumber Display name SIP Advanced Setting Supports the feature, if the proxy does not support Make sure your proxy server or soft switchIt and you enable this feature, all IP outgoing calls Feature is for FXS only Payload Type Setting Page Line Setting No Answer Forward Time FXS only Enable HotlineLine1~Line8 relevant data Type RegPage Differentiated Services Code Point Setting Dscp Qos SettingDscp Signal ToS Setting ToS RTP Speed Dial Editor Speed Dial SettingSpeed Dial Speed Dial Editor In P2P application Peer to Peer call Caller ID Setting Line 1~Line Caller ID SettingDtmf Caller ID Start Symbol Dtmf Caller ID End Symbol Default symbol is C CDR mode CDR Server address CDR Server port CDR SettingPage Syslog mode Syslog Server address Syslog Server port Syslog SettingPage System setting Advanced ConfigurationPage Page Ping ip to keep alive network Ping timersec Sntp Setting Codec Priority Codec SettingCodec Packet Size Bandwidth Required Voice Setting You can set this option for each of the 8 lines Tone Setting Disconnect tone Phone Setting Country Min. Digit Count Digit Manipulation FXO Dial Prefix Third Example Dial PlanDial Plan Editor Page Provision Server Management Export File Import File Save-Reload setting Upgrade Firmware Updating the firmware by FTP Updating the firmware by Tftp Updating the firmware by Http Reset to Default Displays the MAC address of the WAN port Network Status Version Info Boot versionPost version Application version Register Proxy Port StatusPort Type Current password PasswordNew password Confirm new password Rebooting the system Enable the representative line Peer to Peer mode FXO to FXSConfiguration All the line and Disable all the register Enable the representative line Line 1~Line 8 Side B Peer to Peer mode FXS to FXS Page Page Page Specification SP5018A SP5058A Networking