µ
PD75P3116
28 Data Sheet U11369EJ3V0DS
8. ONE-TIME PROM (PROGRAM MEMORY) WRITE AND VERIFY
The program memory contained in the
µ
PD75P3116 is a 16384 × 8-bit one-time PROM that can be electrically written
one time only. The pins listed in the table below are used for this PROM’s write/verify operations. Clock input from the
X1 pin is used instead of address input as a method for updating addresses.
Pin Function
VPP Pin where program voltage is applied during program memory
write/verify (usually VDD potential)
X1, X2 Clock input pins for address updating during program memory
write/verify. Input the X1 pin’s inverted signal to the X2 pin.
MD0 to MD3 Operation mode selection pin for program memory write/verify
D0/P60 to D3/P63 8-bit data I/O pins for program memory write/verify
(lower 4 bits)
D4/P50 to D7/P53
(higher 4 bits)
VDD Pin where power supply voltage is applied. Apply 1.8 to 5.5 V
in normal operation mode and +6 V for program memory write/
verify.
Caution Pins not used for program memory write/verify should be connected to Vss.
8.1 Operation Modes for Program Memory Write/Verify
When +6 V is applied to the VDD pin and +12.5 V to the VPP pin, the
µ
PD75P3116 enters the program memory write/
verify mode. The following operation modes can be specified by setting pins MD0 to MD3 as shown below.
Operation Mode Specification Operation Mode
VPP VDD MD0 MD1 MD2 MD3
+12.5 V +6 V H L H L Zero-clear program memory address
L H H H Write mode
L L H H Verify mode
H×H H Program inhibit mode
×: L or H