27
BASIC OPERATION
Static Convergence Adjustment
Adjust for the red and blue CRTs to place their pattern on top of the
green test pattern (center only).
NOTE: The static convergence adjustment should be performed for
R and B CRT. Carry out the adjustment after displaying an active
image for 20 minutes or more.
Proceed as follows:
1Press the OPERATE button.
•The “OPERATE” menu is displayed.
2Use the CURSOR or button to highlight the “6/STATIC”
line and then press ENTER to display the STATIC adjustment
screen. You can also select the STATIC adjustment screen
directly by pressing the INPUT “6” button , or by pressing the
STATIC button on the remote control.
•The CROSS-HAIR test pattern will be automatically displayed.
3Press the R or B button to display the pattern to be aligned with
the Green pattern (as used a reference color).
•You can turn on or off each CRT beam (R and B) separately.
4Hold down the CTL button then select the CRT you wish to
adjust with the R and B buttons.
5Align the center of the Red or the Blue pattern with the center of
the Green pattern using the CURSOR buttons.
• The CURSOR or button moves the pattern right or left.
The CURSOR or button moves the pattern up or down.
6Repeat steps 3 to 5 for the other CRTs if necessary.
7To end this adjustment, press the END button.
• Whenever the END button is pressed, the screen changes in this
order:
“OPERATE” menu → Source screen
– OPERATE –
1 / PICTURE
2 / POSITION
3 / SOUND
4 / INPUT SELECT
5 / SOURCE INFO
6 / STATIC
7 / CLOSED CAPTION
8 / T I M E R
+10%
–10%V
H
CONVERGENCE
–STATIC–
CRT –R–
Red or Blue
Green