24
Input Selection
You can switch from one input to any other input signal.
Proceed as follows:
1Press the OPERATE button.
•The “OPERATE” menu is displayed.
2Use the CURSOR or button to highlight the “4/INPUT
SELECT” line and press ENTER to display the “INPUT SE-
LECT” list. You can also select the “INPUT SELECT” list
directly by pressing the INPUT “4” button.
3Use the CURSOR or button to highlight the signal to be
switched to and press ENTER to switch to the selected input
signal.
Press the or button to change the sheet.
NOTE: To advance to the next page or to the previous page,
hold down the CTL button then press the CURSOR or
button. To directly access the page, hold down the CTL button
then any one of the INPUT buttons.
4To end the INPUT SELECT list, press the END button.
•Whenever the END button is pressed, the screen changes in this
order:
“OPERATE” menu → Source screen
To select inputs using the INPUT SELECT buttons on the rear
control panel:
1) Press the INPUT button.
•The INPUT SELECT menu is displayed.
2) Press the SELECT button to select an input terminal you wish to
input.
3) Press the ENTER button to execute selection and to switch to the
selected input.
NOTE: Pressing the INPUT button deletes the INPUT SELECT menu
during input selection.
– OPERATE –
1 / PICTURE
2 / POSITION
3 / SOUND
4 / INPUT SELECT
5 / SOURCE INFO
6 / STATIC
7 / CLOSED CAPTION
8 / TIMER
P01/10–1 INPUT SELECT
STANDALONE
NO
01
02
03
04
05
06
07
08
09
10
SOURCE
VIDEO
VIDEO
VIDEO
VIDEO
RGB
INPUT
A
A
A
A
A
NAME
NTSC3.58
NTSC4.43
PAL
SECAM
VESA1024
INPUT SELECT
INPUT A RGB
INPUT A VIDEO
INPUT A S-VIDEO
INPUT A COMPONENT
INPUT B RGB
INPUT B VIDEO
INPUT B S-VIDEO
INPUT B COMPONENT
INPUT C RGB
INPUT C VIDEO
INPUT C S-VIDEO
INPUT C COMPONENT
BASIC OPERATION
OUTPUT DATA : LIST NO.✻✻