NEC XL-3500 Setting Up Your MultiSync Hivid 3500 Projector, Moving The Projector, Selecting A Location, Pulling Out the Handles, Retracting the Handles

123456

1234512345123451234512345 66666 2. INSTALLATION 123456

This section describes how to set up your MultiSync Hivid 3500 projector and how to connect video and audio sources.

Setting Up Your MultiSync Hivid 3500 Projector

To set up and use your MultiSync Hivid 3500 Projector, you must first do:

1.Determine the screen size and the optional lens to be used.

NOTE: Consult your dealer for lens order and installation.

2.Set up a screen or select a non-glossy white wall onto which you can project your image.

Moving The Projector

Always carry your projector by the handle. Ensure that the power cord and any other cables connecting to video sources are disconnected before moving the projector. When moving the projector or when it is not in use, cover the lens with the lens cap.

Selecting A Location

Pulling Out the Handles

Pull out the handle from the bottom side.

Retracting the Handles

Press down the two levers at the same time to retract the handle.

The further your projector is from the screen or wall, the larger the image. The minimum size the image can be projected is 80" (2 m) measured diagonally. The largest the image can be is 500" (12.7 m).

WARNING

•Only use your projector on a solid, level surface. If the projector falls to the ground, you can be injured and the projector severely damaged.

•Do not use the projector where temperatures vary greatly. The projector must be used at temperatures between 32 degrees F (0 degree C) and 104 degrees F (40 degree C).

•Do not expose the projector to moisture, dust, or smoke. This will harm the screen image.

•Ensure that you have adequate ventilation around your projector so heat can dissipate. Do not cover the vents on the bottom or back of the projector.

Screen Size and Projection Distance

1.	Place your projector on a flat level surface at
	the optimal distance from the screen or wall so
	you realize the size image you want. (Avoid
	having bright room lighting or sun light
	directly on the screen or wall where you’ll be
	projecting the image.)
2.	Connect the power cable, remove the lens cap

Screen

Projector

and turn the projector on. (If no input signal is

available, the projector will display a black	Projector
screen.)
screen.)

3.Ensure that the projector is square to the screen.

4.Move the projector left or right to center the image horizontally on the screen.

Screen center

Lens center

Screen