1.PART NAMES AND FUNCTIONS

¿Ä@￿

Loosen the screw by turning

2

and open to access the terminal panel.

5

C

67

 

 

 

 

8

POWER ON/OFF

POWER

STANDBY RCREADY LAMP

9

OFF ON

 

 

 

0

 

 

INDICATOR

 

 

IN

REMOTE2

OUT

A

REMOTE1

IN

OPTION

OUT

B

 

D

E

F

G

VIDEO BNC RCA VIDEO S-VIDEOR/CrG/YB/CbH/HVVOSD OUT

H I J K L M N
BOPTION Connectors (D-Sub 9-pin)

For system expansion such as PC-control.

IN: connect to the external equipment such as PC.

OUT: for daisy-chaining multiple projectors and operating them with the same external equipment. To do so, connect to a second projector’ s IN terminal to relay the input at the IN terminal of the first projector until all the projectors are connected.

CREMOTE 1 Connector (Mini D-Sub 15-pin)

This terminal allows external control of the projector from either the Switcher or from an external control. When the Switcher is used, connect to the REMOTE 1 terminal on the back of the Switcher.

NOTE: The ISS-6020/ISS-6020G Switcher is compatible with this projector.

DINPUT E

Not used.

EINPUT D

Used for the factory-installed video processor only.

FINPUT C

Slot for adding optional RGB or video input cards.

GINPUT B

Slot for adding optional RGB or video input cards.

HVIDEO Input BNC Terminal (INPUT A)

Connect to the BNC video output of the external equip- ment such as a VCR or laser disk player.

IVIDEO Input Select Switch

Selects VIDEO input between BNC and RCA type.

JVIDEO Input RCA Terminal (INPUT A)

Connect to the RCA video output of the external equip- ment such as a VCR or laser disk player.

KS-VIDEO Input Terminal (INPUT A)

Connect to the S-video output of the external equipment such as a VCR with an S-video output.This terminal allows switching between S2 and S1 VIDEO input modes. See the “S-Video Mode” section for more information.

LActive Indicator (green LED)

Lights up when the INPUT A slot is selected.

MR/Cr, G/Y, B/Cb, H H/V and V Input Terminals (INPUT A)

Connect R,G,B,H (Horizontal sync) and V (Vertical sync) outputs of the external equipment such as the Switcher). If using a component with a combined sync (SYNC)output, connect it to the H/V terminal.

Connect component video outputs of the external equip- ment such as DVD player.

NOSD OUT Connector (Mini D-Sub 15-pin)

Outputs on-screen information. You can use this connec- tor to loop your on-screen information to an external monitor.

NOTE:

1)A picture may be distorted or no picture may appear when any one of the following procedures is performed:

*An XGA signal is input to the projector.

*A High-refresh signal in SVGA is input to the projector. 2)Some types of monitor may display no image on the screen.

9