3.OPERATION

■Registry Edit

This feature allows you to change various parameters of the source on the selected line. This can be done to the current projected signal as well as not projected source.

To edit the registered signal, proceed as follows:

1)Press the ADJUST button.

•The Adjust menu is displayed.

2)Use the CURSOR or button to highlight the “1.Source Registry” line and press ENTER.

•The Source Registry menu will be displayed.

•You can also select the Source Registry menu directly by pressing the INPUT “1” button.

Items to select

•New Entry ------------ Registers a new signal.

•Registry Edit --------- Changes setting various parameters of the registered signals.

3)Use the CURSOR or button to highlight the “2. Registry Edit” line and press ENTER.

•The “Registry Edit” screen is displayed.

4)Use the CURSOR or button to highlight the registered signal and press ENTER.

•The “Edit Command” menu is displayed. Then proceed as follows:

*Cut Enables you to remove a selected signal from the list and place it on the “clipboard” in the projector.

*Copy Enables you to copy a selected signal from the list and place it on the “clipboard” in the projector.

*Paste Enables you to paste the signal placed on the “clip- board” to any other line of the list. To do this, select “Paste” and then select the line number you want to paste to. Last press ENTER.

*Information Enables you to set a various parameters. When “Information is selected, the Source Information screen is displayed. Select an item and press ENTER.

5)When setting is completed, press END.

NOE: The contents will leave the “clipboard” when you press

END.

E d i t C o m m a n d C u t

C o p y P a s t e

I n f o r m a t i o n

47