3.OPERATION

mAddressing the Remote Control Unit

When changing the projector address, ensure that the projector address respond to the remote control address, otherwise you cannot operate the projector using the remote control.

To specify the remote control address, proceed as follows:

1)Press and hold the CTL button then press the ADDRESS button to access the RC UNIT address mode.

•The current remote control address is displayed on the remote control address screen. (When the current remote control address is configured at "00", the remote control address screen will not be displayed.

•This screen will disappear in 30 seconds.

NOTE: When the remote control is used with the Switcher in wired application, a window shown on the right will not be displayed. However, the remote control address can be changed.

2)Use INPUT buttons to enter a new two-digit number and press

ENTER.

•The new remote control address is displayed on the screen. When the new remote control address is configured at "00", the display will not be changed. However, its address has been changed by pressing ENTER.

•The number you can specify ranges from 00 to 64.

To stop the address changing, press END.

See the projector address number on the screen.

NOTE:

•The buttons other than the above mentioned button and the OFF button are not available during specifying the remote control address.

•If no key input is made within 30 seconds, the remote control automatically exits the RC UNIT address mode.

Address common to all the projectors

When specifying the remote control address as “00”, you can operate the projector using the remote control, regardless of the projector addresses.

If the remote control loses power, the remote control address becomes “00”. In this case the on-screen shown on the right above is not displayed on the screen.

3) To complete, press END.

A D D R E S SR C U N I T ∗∗

When the remote control address is configured at "00", the above screen will not be displayed.

73