NetComm Rear Panel, Network Cable Connector, External Antenna for NS370W only, Reset Button

Rear Panel

1.Network Cable Connector

The Internet Camera’s rear panel features an RJ-45 connector for connections to 10Base- T Ethernet cabling or 100Base-TX Fast Ethernet cabling (which should be Category 5 twisted-pair cable). The port supports the N-Way protocol and “Auto-MDIX” function, allowing the Internet Camera to automatically detect or negotiate the transmission speed of the network.

2.External Antenna (for NS370W only)

The rotatable external antenna allows you to adjust its position to obtain the maximum signal.

3.Reset Button

Reset will be initiated when the reset button is pressed once, and Power LED begins to flash.

Factory Reset will be initiated when the reset button is pressed continuously for three seconds or when Power LED begins to light up. Release the reset button and the Power LED will begin to flash, indicating the Internet Camera is changing to factory reset. When factory reset is completed, the Internet Camera will be set to default on channel 11 and SSID is set as “NULL String” (This default setting will let the Internet Camera connect to ANY access point on the infrastructure network). The IP address will also return to the default setting as 192.168.0.20.

4.DC Power Connector

The DC power input connector is located on the Internet Camera’s rear panel, and is labelled DC5V with a single jack socket to supply power to the Internet Camera. Power will be generated when the power supply is connected to a wall outlet.

Top/Bottom Panel

Screw Hole

Located on the top/bottom panel of the camera, the screw hole is used to connect the camera stand onto the camera by attaching the screw head on the camera stand into the screw hole of the camera.

NS370 / NS370W User Guide	9
YML814 Rev1