DM111P ADSL2+ Ethernet Modem Reference Manual
•If the LAN port is lit, but the Internet port is not, log in to the modem interface, as described in “Opening the
Troubleshooting the Web Management Interface
If you are unable to access the modem’s Web Management interface from your computer check the following:
•Check the Ethernet connection between the computer and the router as described in the previous section.
•If your computer is directly connected to the modem, make sure your computer’s IP address is on the same subnet as the modem. If you are using the recommended addressing scheme, your computer’s address should be in the range of 192.168.0.2 to 192.168.0.254. Follow the instructions in “Preparing a Computer for Network Access:” in Appendix B to configure your computer.
Note: If your computer’s IP address is shown as 169.254.x.x:
Recent versions of Windows and MacOS will generate and assign an IP address if the computer cannot reach a DHCP server. These
•If your modem is connected to your computer via a router, make sure the computer’s IP address is on the same subnet as the router, and the router is on a different subnet from the modem. The LAN IP addresses of the modem and router will normally be printed on a label on the bottom or rear of the unit. For details about changing the modem’s IP address, see “Setting Up Your Ethernet Connection” on page
•If your modem’s IP address was changed and you do not know the current IP address, clear the router’s configuration to factory defaults. This will set the router’s IP address to 192.168.0.1. This procedure is explained in “Using the Reset button” on page
•Make sure your browser has Java, JavaScript, or ActiveX enabled. If you are using Internet Explorer, click Refresh to be sure the Java applet is loaded.
•Try quitting the browser and launching it again.
Troubleshooting |
