Reference Manual for the ProSafe VPN Firewall 25 with 4 Gigabit LAN and Dual WAN Ports

Table 2-1.

FVS124G front panel

 

 

 

Object

Activity

Description

 

 

 

PWR LED

On (Green)

Power is supplied to the firewall.

 

Off

Power is not supplied to the firewall.

 

 

 

TEST LED

On (Amber)

Test mode: The system is initializing or the initialization has failed.

 

Blinking (Amber)

Writing to Flash memory (during upgrading or resetting to defaults).

 

Off

The system has booted successfully.

 

 

 

WAN Port

Link/Act LED

 

LEDs

On (Green)

The WAN port has detected a link with a connected Ethernet device.

 

Blinking (Green)

Data is being transmitted or received by the WAN port.

 

Off

The WAN port has no link.

 

 

 

 

100 LED

 

 

On (Green)

The WAN port is operating at 100 Mbps.

 

Off

The WAN port is operating at 10 Mbps.

 

 

 

 

Active LED

 

 

On (Green)

The WAN port has a valid Internet connection.

 

On (Amber)

The Internet connection is down or not being used.

 

Off

The WAN port is either not enabled or has no link.

 

 

 

Gigabit LAN

Link/Act LED

 

Port LEDs

On (Green)

The LAN port has detected a link with a connected Ethernet device.

 

Blinking (Green)

Data is being transmitted or received by the LAN port.

 

Off

The LAN port has no link.

 

Speed LED

 

 

On (Green)

The LAN port is operating at 1,000 Mbps.

 

On (Amber)

The LAN port is operating at 100 Mbps.

 

Off

The LAN port is operating at 10 Mbps.

 

 

 

The Router’s Rear Panel

The rear panel of the FVS124G ProSafe VPN Firewall 25 with 4 Gigabit LAN and Dual WAN Ports (Figure 2-2) contains the factory defaults reset button, LAN and WAN ports, and DC power input connection.

Introduction

2-7

202-10085-01, March 2005

Page 25
Image 25
NETGEAR FVS124G manual Router’s Rear Panel, Object Activity Description