NETGEAR FVS124G manual Inbound Services, Services menu see Customized Services on

Reference Manual for the ProSafe VPN Firewall 25 with 4 Gigabit LAN and Dual WAN Ports

Table 6-1.	Inbound Services
Item		Description
Services		Select the desired Service or application to be covered by this rule. If the desired
		service or application does not appear in the list, you must define it using the
		Services menu (see “Customized Services” on page 6-16).
Action		Select the desired action for packets covered by this rule:
		• BLOCK always
		• BLOCK by schedule, otherwise Allow
		• ALLOW always
		• ALLOW by schedule, otherwise Block
		Note: Any inbound traffic which is not allowed by rules you create will be blocked by
		the Default rule.
Select Schedule		Select the desired time schedule (i.e., Schedule1, Schedule2, or Schedule3) that will
		be used by this rule.
		• This drop down menu gets activated only when "BLOCK by schedule, otherwise
		Allow" or "ALLOW by schedule, otherwise Block" is selected as Action.
		• Use schedule page to configure the time schedules.
LAN users		These settings determine which computers on your network are affected by this rule,
		based on their IP address. Select the desired IP Address in this field.
WAN Users		These settings determine which Internet locations are covered by the rule, based on
		their IP address. Select the desired option:
		• Any - All Internet IP address are covered by this rule.
		• Single address - Enter the required address in the start fields.
		• Address range - If this option is selected, you must enter the start and finish fields.
Destination Address		These settings determine the destination IP address for this rule which will be
		applicable to incoming traffic, this rule will be applied only when the destination IP
		address of the incoming packet matches the IP address of the WAN interface
		selected or Specific IP address entered in this field.Selecting ANY enables the rule
		for any IP in destination field.similarly WAN1 and WAN2 corresponds to respective
		wan interfaces.
QoS Priority		This setting determines the priority of a service, which in turn, determines the quality
		of that service for the traffic passing through the firewall. By default, the priority
		shown is that of the selected service. The user can change it accordingly. If the user
		does not make a selection (i.e, leaves it as None), then the native priority of the
		service will be applied to the policy. +5 is the highest priority. See “Quality of Service
		(QoS) Priorities” on page 6-18.
Log		This determines whether packets covered by this rule are logged. Select the desired
		action:
		• Always - always log traffic considered by this rule, whether it matches or not. This is
		useful when debugging your rules.
		• Never - never log traffic considered by this rule, whether it matches or not.
6-6		Firewall Protection and Content Filtering

202-10085-01, March 2005