GS748T Software User Manual
2-4 Getting Started—Smart Wizard Discovery
v2.0, April 2007
NIC Setting on the Host that Accesses the GS748T Smart Switch
The settings of your network interface card (NIC) under MS Windows OS are made with entries
into the Windows screen pages shown below. For comparison, the settings pages of the switch are
also shown although they do not appear in the Windows view.
You need Windows Administrator privilege to change these settings.
1. On your PC, access the MS Windows operating system TCP/IP Properties page as shown. In
MS Windows XP this is found in Control Panel > Network Connections > Local Area
Connection > General: Properties.
2. Select Internet Protocol (TCP/IP) and click on Properties.
3. Set IP address and subnet mask appropriately. The subnet mask value should be identical to
that set in the switch. The PC IP address must be different from that of the switch but lie in the
same subnet.
4. Click on the Web Access button to enable the management screens as described in the
following section
Figure 2-4