GS748T Software User Manual
Basic Web Management 3-7
v2.0, April 2007
The switch default state allows access from any IP address. If you enter authorized IP
addresses, be sure to include the IP address of your own management PC.
• Set-up: The following diagram shows a typical Set-up screen. Use it to enter the name and
location of your switch. If you want to use a DHCP server, make the appropriate setting. If you
enable Static IP Address, enter your IP address, Subnet Mask, and Gateway values as shown.
• Password: Use this page to set a new password. Be sure to note your setting. If you forget the
password, you must perform a factory reset of the switch to regain management access to it. In
this case you will lose your configuration settings because they are overwritten by factory
default values. However, if you have saved your configuration using Configuration Backup,
you can recover the overwritten values.
Firmware Menu
This menu item is found at the bottom of the menu bar. It contains Configuration Backup and
Factory Reset submenu items. These topics are described at this stage of the description because
their utility may be needed early in the configuration process.

Managing System Files—Backup and Restore

This facility may be used to protect your system configuration and save a possibly long manual
configuration in case of a loss or an accidental manual factory reset.
Figure 3-4