Reference Manual for the Model RP614 Web Safe Router
2-6 Setting Up the Hardware
1. Plug the connectorof the power adapter into the power adapter outlet on the rear panel of the
router.
2. Plug theother end of the adapter into a standard wall outlet.
3. Verifythat the Power LED on the router is lit.
Verif ying Pow er
After connectingthe power adapter to the router and a power source, the router powers on
automatically.Complete the following steps to verify that power iscorrectly applied to the router:
1. When power is first applied,verify that the Power LED comes on.
2. During thefirst 10 seconds, all LEDs will be tested.
3. After approximately10 seconds, verify that:
a. The TestLED is not lit.
b. The Local port LEDs are litfor any local ports that are connected.
c. The Internet port LED is lit.
If a port’sLED is lit, a link has been established to the connected device.If a Local port is
connectedto a 100 Mbps device, verify that the port’s LED isgreen. If the port is 10 Mbps, the
LED will be amber.
Youare now ready to begin configuration of your network, as describedin the following chapter.