Wireless Access Point

Point-to-Point

Mode

Point-to-Point

Mode

Note: The 54 Mbps

repeater modes are

only compatible with

WG302 Wireless

Access Points.

 

1.Verify the following parameters

Verify that the LAN network

Access Points are configured

 

to operate in the same LAN network

LAN devices

If using DHCP, all WG602 v2 Access Points

set to “Obtain an IP address

automatically (DHCP Client)” in the IP Address Source portion of the Basic IP Settings menu.

If MAC access control list security is enabled on the APs, verify that the MAC access control lists on each AP are complete for the entire network and accurate.

All WG602 v2 Access Points use the same SSID, Channel, WEP authentication mode, if any, and encryption in use (WPA is not available in bridge modes).

All Point-to-Point APs must have AP2’s MAC address in its Remote AP MAC address table. You can locate the MAC address in the Information page of each WG602 v2.

Advanced Configuration

5-3

M-10181-03

Page 51
Image 51
NETGEAR WG602 V2 manual Repeater modes are