NETGEAR WG602 V2 manual General Information Fields

Reference Manual for the WG602 v2 54 Mbps Wireless Access Point

Table 4-1.	General Information Fields
Field		Description
Access Point Information
Access Point Name		The default name can be changed if desired.
MAC Address		Displays the Media Access Control address (MAC Addresses) of the
		wireless access point’s Ethernet port.
Region		Displays the country or region for which the wireless access point is
		licensed for use. It may not be legal to operate this wireless access point in
		a region other than one of those identified in this field.
Firmware Version		The version of the firmware currently installed.
Current IP Settings		These parameters apply to the Local WG602 v2 wireless access point.
IP Address		The IP address of the wireless access point.
Subnet Mask		The subnet mask for the wireless access point.
Default Gateway		The default gateway for the wireless access point.
DHCP Client		Enabled by default. Enabled (DHCP client) indicates that the current IP
		address was obtained from a DHCP server on your network.
Wireless Settings		These parameters apply to the target remote WG602 v2, VPN gateway, or
		VPN client.
Wireless Network Name		Displays the wireless network name (SSID) being used by the wireless port
(SSID)		of the wireless access point. The default is NETGEAR.
Channel		Identifies the channel the wireless port is using. 11 is the default channel
		setting. See “Wireless Channels” on page B-2for the frequencies used on
		each channel.
Encryption Type		The current encryption setting.
Access Control		Disabled by default.

4-2 Management

M-10181-03