NETGEAR WG602 V2 manual Wireless

Reference Manual for the WG602 v2 54 Mbps Wireless Access Point

2.Configure AP1 in Point-to-Point mode with the MAC address of AP2 and deploy it on LAN Segment 1. If you check the Enable Wireless Client Association checkbox, wireless clients will also be able to use AP1. If the Enable Wireless Client Association checkbox is not selected, only computers on Ethernet LAN segment 1 will use AP1 to communicate with AP2.

3.Configure AP2 in Point-to- Segment 2. Use the same Wireless Client Association Enable Wireless Client LAN segment 2 will use AP2

4.Verify connectivity across

mode with the MAC address of AP1 and deploy it on LAN and channel settings as AP1. If you check the Enable

wireless clients will also be able to use AP2. If the is not selected, only computers on Ethernet with AP1.

If you enabled wireless client to connect to the Internet or the network.

on either AP should be able PCs or servers connected to

Point-to-Point	Point-to-Point
Mode
	Mode
Point-to-Multipoint
Mode

Figure 5-4: Wireless

Note: The 54 Mbps	repeater modes are
only compatible with	WG302 Wireless
Access Points.

1.Verify the following parameters

5-4 Advanced Configuration

M-10181-