NETGEAR WGU624 Chapter Connecting the Router to the Internet, What You Will Need Before You Begin

Chapter 3

Connecting the Router to the Internet

This chapter describes how to set up the router on your local area network (LAN) and connect to the Internet. You will find out how to configure your Double 108 Mbps Wireless Firewall Router WGU624 for Internet access using the Setup Wizard, or how to manually configure your Internet connection.

What You Will Need Before You Begin

You need to prepare these three things before you begin:

1.Have active Internet service such as that provided by an cable or DSL broadband account.

2.Locate the Internet Service Provider (ISP) configuration information for your DSL account.

3.Network capability to connect the router to a cable or DSL modem and a computer as explained below.

Cabling and Computer Hardware Requirements

To use the WGU624 wireless router on your network, each computer must have an installed Ethernet Network Interface Card (NIC) and an Ethernet cable. If the computer will connect to your network at 100 Mbps, you must use a Category 5 (Cat 5) cable such as the one provided with your router. The cable or DSL broadband modem must provide a standard 10 Mbps (10BASE-T) or 100 Mbps (10BASE-Tx) Ethernet interface.

Computer Network Configuration Requirements

The WGU624 includes a built-in Web Configuration Manager. To access the configuration menus on the WGU624, your must use a Java-enabled Web browser program that supports HTTP uploads such as Microsoft Internet Explorer or Netscape Navigator. Use Internet Explorer or Netscape Navigator 4.0 or above.

For the initial setup of your router, you need to connect a computer to the router. This computer has to be set to automatically get its TCP/IP configuration from the router via DHCP.

Connecting the Router to the Internet 3-1

M-10153-01