New Buck Corporation DV1000 specification

WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

FIGURE 14

“Apply loose material per instructions manual. DO NOT apply extra material or material not sup- plied with the heater. Replace only with material from your Buck Stove dealer or from New Buck Corporation.

WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

This appliance must be installed in accordance with local codes if any. If none, then follow the National Fuel Gas Code, ANSI Z223.1/NFPA 54, or Natural Gas and Propane Installation Codes, CSA -B149.1.

“CAUTION: Do not operate the appliance with glass removed, cracked or broken. Re- placement of the panel(s) should be done by a licensed or qualified service person.”

Page 19

Image 22

New Buck Corporation DV1000 manual

Contents

ZERO CLEARANCE DIRECT VENT GAS FIREPLACE DV1000Approved By Page TABLE OF CONTENTS Page INTRODUCTION AND SAFETY FOR INSTALLATION AND OPERATION DV1000 FIREBOX COVER DOOR REMOVAL INSTRUCTIONS LOUVER ASSEMBLY 1. TOP LOUVER ASSEMBLY2. BOTTOM LOUVER ASSEMBLY VER ASSEMBLY CLIP TO SECURE TO STOVE BODY 16-15/16” 2-1/2” 6” DV1000 SPECIFICATIONS38-1/8” 36” 33-1/2” TOP STANDOFFS SIDE STANDOFFS 27-1/8” 13-9/16” 2-1/2” MINIMUM FRAMING DIMENSIONS40-1/8” 36-1/8 VENT TERMINAL CLEARANCES Page DETERMINING THE LOCATION FOR DV1000 INSTALLATION INSTRUCTIONS DV1000 DIRECT VENT TERMINATION PRE-INSTALLATIONINFORMATION PIPE INSTALLATION OUTER 7” VENT PIPE INNER 4” FLUE PIPE 9-1/2”WALL CORNER TERMINATION WITH OPTIONAL REAR VENTFIGURE 8/ OPTIONAL REAR VENT TER MINATION EXAMPLE MINIMUM INSTALLATION MAXIMUM INSTALLATION DV1000 STANDARD VERTICAL CHASE TERMINATION INSTALLATIONSVERTICAL TERMINATION CAP ASSEMBLY 30FT MAX REMOVABLE INNER BOTTOM PAN ASSEMBLY GAS SUPPLY CONNECTION INSTALLING GAS PIPING TO APPLIANCEInstallation Items Needed CHECK GAS TYPE Pressure Testing Gas Supply Piping System Test Pressures In Excess of 1/2 PSIG 3.5 kPa DV1000 LOG PLACEMENT ance of the heater WARNING Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury FOR YOUR SAFETY READ BEFORE LIGHTING WHAT TO DO IF YOU SMELL GAS LIGHTING INSTRUCTIONS TO TURN OFF GAS TO APPLIANCE WIRING DIAGRAM SERVICING REPAIR PARTS CLEANING AND MAINTENANCE LOGS BURNER PAN ASSEMBLYVENTURA ASSEMBLY Air Shutter Slot Opening EMBERS POSSIBLE CAUSE TROUBLESHOOTINGOBSERVED PROBLEM REMEDY Diagram, page Burner does not light after pilot is lit Continued TROUBLESHOOTINGMaintenance, page Gas leak. See Warning statement KEY# REPLACEMENT PARTSSERVICING PART DESCRIPTION ON/OFF/MANUAL Page ADDITIONAL REPLACEMENT PARTS PROCEDURE WARRANTYWARRANTY CONDITIONS AND EXCLUSIONS OTHER RIGHTS Page