New Buck Corporation DV1000 manual Top Louver Assembly, Firebox Cover Door, Bottom Louver Assembly

1.The top louver assembly must be removed first. To remove the top louver assembly you must place your hands one at the bottom left corner and the other at the bottom right corner of the lou- ver assembly. Then with both hands lift up and outwards to release the louver clips from the stove body. After removing the louver assembly place it in a safe place until time to reinstall.

2.The bottom louver assembly must be in the open position to access the firebox cover door fas- teners. The bottom louver assembly is hinged to the bottom of the stove. Place one hand on the center of the top louver and pull slowly out and downward to open.

3.Before removing the firebox cover door you must remove the six (6) 1/4-20 nuts located across the top of the door and the bottom of the door. After removing the nuts you must slowly pull the door outward and completely off the studs. Place the door in a safe place until time to reinstall, the glass is breakable.

NOTE: The Firebox Cover Door must be removed to access the pilot assembly located in the right rear corner of the firebox area, and to access the burner pan located in the bottom center of the firebox area. The door must also be removed when placing the logs and embers.

4. To replace the cover door, reverse steps 3 thru 2.

1. TOP LOUVER ASSEMBLY
3. FIREBOX COVER DOOR
2. BOTTOM LOUVER ASSEMBLY
FIGURE 1	RIGHT SIDE
LEFT SIDE
	FRONT

	#1 SIDE VIEW OF
#1	LOUVER ASSEMBLY
	AND CLIP.

SLOT IN STOVE BODY FRONT FOR LOU-

VER ASSEMBLY CLIP TO SECURE TO

STOVE BODY.

1/4-20 NUTS

#3

#2

Replace the entire cover door assembly if glass becomes defective with part # PO COVDOR1.

Page 4