INSTALLATION
Continued
9.Attach stove door by inserting step bolt through door hinge pivot hole and into threaded hole in stove body (See Figure 9 and 10 on page 8). Use an adjustable wrench or a 12mm socket to fasten step bolt. Tighten step bolt until snug. Make sure door moves freely.
10.Install door catch bolt (M8 x 1.25
– 55mm with two M8 hex nuts) into threaded hole on stove body (See Figure 10, page 8). Use an adjustable wrench or a 12mm socket. The catch bolt has two hex nuts attached to it. The top nut is a bolt stop and the bottom nut is for door leveling adjustment.
11. Check general catch bolt alignment with door claw. Make final adjustment and door leveling after stove is in normal standing position.
12.Carefully lift stove back up on its four attached legs.
13.Set top grate into stove top.
14.If available, install gas log heater inside stove cavity before installing the back panel (See Installing Gas Log Heater Into Stove, page 9).
15.Fasten back panel to stove with six (6) M6 x
WASHERS | BOTTOM OF |
BOLTS | STOVE UNIT |
FIGURE 8 - ATTACHING STOVE LEGS
NOTE: IF YOUR CASTING HAS A DROP BOTTOM– DO NOT INSTALL– DISCARD THE BOTTOM.
STOVE DOOR
STOVE DOOR
BOLT
THREADEDSHOULDER HOLE
DOOR | DOOR | |
HINGE | ||
HINGE | ||
|
DOOR 
STEP |
| STEP |
| BOLT | |
BOLT | BOLT |
|
| SHOULDER | STOVE BOTTOM |
|
|
FIGURE 9 - ATTACHING STOVE DOOR
BOLT STOP
ADJUSTING NUT
DOOR CLAW
CATCH BOLT
FIGURE 10 - CATCH BOLT AND DOOR CLAW ORIENTATION
8
