Problem

Cause/Solution

A

 

 

 

The camera automatically turns off to save

23

 

 

 

power (auto off function).

 

 

 

 

The camera or battery has become too cold

F4

 

 

 

and cannot operate properly.

 

 

 

Camera turns off

The inside of the camera has become hot.

 

 

Leave the camera off until the inside of the

 

 

 

without warning.

 

 

 

camera has cooled, and then try turning it

 

 

 

 

 

 

 

 

on again.

 

 

 

 

The camera turns off if the USB cable

92, 95,

 

 

 

connecting it to a computer or printer is

E23

 

 

 

disconnected. Reconnect the USB cable.

 

 

 

 

 

 

 

 

 

The camera is off.

22

 

 

 

The camera has entered standby mode to

23

 

 

 

save power. Press the power switch,

 

 

 

 

shutter-release button, Abutton, c

 

 

 

 

button, or b(emovie-record) button.

 

 

 

 

The flash lamp flashes while the flash is

48

 

 

Monitor is blank.

charging. Wait for the flash to charge.

 

 

 

The camera and computer are connected

92, 95

 

 

 

 

 

 

via the USB cable.

 

 

 

 

The camera and TV are connected via an

92,

 

 

 

HDMI cable.

E21

 

 

 

Camera and smart device are connected

89

 

 

 

using Wi-Fi connection and the camera is

 

 

 

 

operated by remote control.

 

 

 

Monitor is hard to

Adjust the monitor brightness.

76,

 

 

 

E65

 

 

read.

The monitor is dirty. Clean the monitor.

 

 

F7

 

 

 

 

 

 

 

 

Technical

 

 

If the camera clock has not been set, the

 

 

 

“Date not set” indicator flashes during

 

 

 

 

 

 

 

 

shooting and movie recording. Images and

 

 

 

 

movies saved before the clock is set are

 

Notes

 

 

dated “00/00/0000 00:00” or “01/01/2014

 

 

Date and time of

00:00” respectively. Set the correct time and

18, 76,

 

 

recording are not

date from the Time zone and date option

and

 

E63

 

correct.

in the setup menu.

 

 

 

 

Index

 

 

The camera clock is not as accurate as

 

 

 

ordinary watches or clocks. Periodically

 

 

 

 

 

 

 

 

compare the time of the camera clock with

 

 

 

 

that of a more accurate timepiece and reset

 

 

 

 

 

 

 

 

as required.

 

 

 

 

 

 

F10