Nikon 58-104 manual ~·i, Release the shutter on the camera

Turn ON the power switches on	o
3both Speed lights, and be sure the
ready-li ghts are li t.	~·i
	OFFOW
	G>
Release the shutter on the camera.
4-When the Speedlight (connected to the
camera) fires, the another Speedlight
(SB·104) will fire simultaneously.

e Caution

e lf there are other people in the area firing a Speedlight, it may cause your slave unit to fire also.

e The slave unit normally fires only when it senses a sudden burst ofI light. However, it can also fire in the event a lamp such as a

fluorescent light flickers when it is turned ON. However, there is no abnormality in this case.

+Notes

+The slave unit fires when light from the master unit activates the slave unit's sensor. The maximum distance under water at which the slave unit can react to light from the master unit is about 10 meters (32.8 feet) when the master unit is directly facing the slave unit'ssensor. However, the slave unit may not fire if the water is cloudy or there is strong external light. Test fire the Speedlights in advance to be sure the Flash Slave will work properly.

+The standby function does not work in Flash Slave mode. Battery power will thus be consumed in about 10 minutes, the equivalent power needed to fire the flash once in manual full output. At this rate, battery power will be used up in about 20 hours even without a single firing of the flash .

51