Nikon Nikon N75 instruction manual ~E3 n3@ @, OX-coded film

3 Gently close the camera back until the camera back snaps closed .

It':

Ic S FS.6

B~E::3 n3@ @

•The fi lm automatically advances to the final frame with blinking 0 , 0 _ , 0 __ , 0 __ _

as indicated in the LCD panel , and film rewinds one frame at a time as photos are taken. The LCD panel indicates number of exposures left on film .

•When the film has completed set up, a shutter sound is let out but no picture has been taken .

•When E appears in the LCD panel, or Err and E in the LCD panel and 8_ in the viewfinder blink, film is not properly installed . Open the camera back again and reload fi lm by aligning the film leader to the red index mark. 8 blinks in the viewfinder when the film is not loaded.

•Pictures taken on frames beyond the indicated number of the exposures for the film roll may be discarded in the process of developing .

001'ffil!Jc :Warning indicat ions in t he viewfinder can be set not to appear (p. 74).

z o

ia;

w a:

Q.

OX-coded film

With OX-coded film , film speed will be set automatically between ISO 25 to ISO 5000. Film speed is set to ISO 100 with non- OX- coded film .

OX-coded fi lm

~ISO

(film speed)

36

OX mark

Check points

•Avoid direct sunlight when changing film outdoors.

•You can check the number of available exposures on the film roll and fil m speed through the film confirmation window.

•Infrared films cannot be used with this camera since an infrared sensor is used for the detection of the film frame position .

21