Nikon SB-28 instruction manual TTL Auto Flash t Mode, Flash settings, flash mode, Select the

TTL Auto Flash t Mode

			For cameras in Group III: F-601/N6006, F-601M/N6000
Flash settings		flash mode.
4	Select the
	—Press the µ button until t appears on the LCD panel.
				• Set your camera to the Matrix
				Balanced Fill Flash or Center-
				Weighted Fill-Flash/Spot Fill-Flash
				mode.

5Check the shooting distance.

A flash shooting distance range of 0.8 to 6m (2.6 to 20 ft) is shown.

Nikkor lenses with a built-in CPU

• In any exposure mode:

—Press the { or } button until the same aperture as displayed on the camera’s LCD panel or in viewfinder is set on the SB-28’s LCD panel, then confirm the flash shooting distance range.

Nikkor lenses without a built-in CPU

• In Aperture-priority auto (A) or Manual (M) mode only:

—Press the { or } button until the same aperture on the lens is set on the SB-28’s LCD panel, then confirm the flash shooting distance range.

6Wait for the ready-light to come on and make sure the subject is in focus before taking the picture.

• If the ready-light blinks for approx. 3 seconds after shooting, this indicates the light may have been insufficient for correct exposure. In this case, use a wider aperture or move closer to the subject.

34