INSTALLATION
Before you begin, make sure that all of the cables and wires, as well as the power supply cable will reach the proposed location of the
STEPS:
1) IC2 REMOTE BATTERY
The iC2 Remote rechargeable battery needs to be connected and charged. The installer needs to remove the battery cover with a Phillips screwdriver. The plug on the battery is keyed and only allows it to be plugged in one way. Plug in the battery and position it in the compartment next to the positioning foam.
2) LABEL THE MASTER KEYS ON THE IC2 REMOTE
The Master Keys on the iC2 Remote can be labeled using the supplied label sheet and plastic key caps. The iC2 worksheets should be filled out prior to labeling the Master Keys. Based on the worksheet, peel off the appropriate label from the sheet and place it on the corresponding Master Key. The plastic key caps are molded with one end rounded and the other flat. Orient the key cap correctly over the Master Key; push the key cap down on the Master Key until it sits flush with the molded portion of the iC2 Remote.
3) CONNECT THE CHARGING POWER SUPPLY
�
��
����������
Figure 13.
iC2 Remote’s 8 custom label Master Keys
The rechargeable battery for the iC2 Remote may still have a charge, but we recommend plugging the iC2 Remote to the charging power supply. The iC2 System comes with two identical power DC power supplies. Choose one of them and plug the
Figure 14. Ferrite bead on iC2 Remote power supply cable
18
