GB

Single disc machine

Machine equipment 1. Handle bar

2. Brush motor switch

3. Housing of top shaft element

4. Swith lock

5. Shaft adjustment handle

6. Screws on switch cabinet

7. Bar

8. Cable hook

9. Wheels

10. Motor head

11. Brush

12. Outlet hose

13. Liquid tank

14. Tank holder

15. Tank lever

16. Water connector

17. Shaft adjustment unit

18. Electric cable

19. Drive plate for pads

20. Spraymaster

21. Pad

These operating instructions are intended for operating staff.

1. Please familiarize yourself with the instructions and recommendations contained in these operating instructions before setting up, commissioning and servicing the machine.

2. You will then have full control over the machine and use it efficiently. The care and maintenance described in these operating instructions are in the interests of your own safety and preserve the machineʼs value.

3. The manufacturer accepts no liability for personal injury or damage to property due to the incorrect use of this machine.

Please read the safety instructions carefully!

Safety instructions

Before commissioning the single-disc machine, please read these instructions carefully and keep them handy at all times.

The single-disc machine may only be used by persons trained in its use and explicitly entrusted with its operation.

Warning!

The single-disc machine is not suitable for cleaning surfaces which release health-hazardous dusts and liquids. Do not use the machine on steps.

Caution!

Never drive the machine over electric cables. Danger of electric shocks!

General remarks

The operation of the single-disc machine is subject to the currently valid national regulations.

It is essential to observe not only the operating instructions and the binding regulations on accident prevention valid in the country of use, but also the generally acknowledged rules for safe and correct working procedures. No methods involving safety risks must be employed. The use of automatic machines on public paths and roads is prohibited.

Correct use

All single-disc machines are intended exclusively for use in building interiors.

Any use beyond this is considered incorrect. The manufacturer accepts no liability for any resultant damage; the user alone bears the risk.

Correct use also includes adherence to the operating, servicing and maintenance conditions recommended by the manufacture.

The relevant accident prevention regulations as well as all the generally acknowledged safety and working practices must be followed.

Unauthorized modifications to the machine exclude the manufacturerʼs liability for resultant damage.

Before machine use, floorcoverings must be tested for suitability for this cleaning process.

Pay attention to the area compression of point-elastic floors, e.g. in gymnasiums

The manufacturer accepts no liability for damage to equipment and to the floor being cleaned from using the wrong brushes and cleaning agents.

Product liability

The operatorʼs attention is drawn explicitly to the fact that the machines may only be used for their intended purpose. If the machines are not used for their intended purposes, the user must accept full responsibility. Any liability of the manufacturer ist thus excluded.

Sources of risk

When the machine is stationary, the brush unit must be immediately switched off to prevent damage to the floorcovering.

During transportation in lifts, the currently valid user instructions and safety regulations – and particularly those concerning maximum loading

– must be observed.

Machine operation position

The machine operation position is behind the machine.

Approved maintenance staff

The single-disc machine may only be serviced and repaired by persons with technical and legal authorization.

Cleaning agents

When using cleaning and care agents, the manufacturerʼs danger warnings must be followed and protective goggles and clothing must be worn.

Only muse low-foaming, non-combustible cleaning agents which do not contain generally health- hazardous substances.

7