Nilfisk-ALTO 4800, 5400, 4300 A-4 /ENGLISH, Introduction, Parts And Service, Nameplate, Un-Crating

A-4 / ENGLISH

INTRODUCTION

This manual will help you get the most from your Nilsk-Advance ™ Sweeper / Scrubber. Read it thoroughly before operating the machine. References to “right” and “left” in this manual mean right or left as seen from the driver’s seat.

Note: Bold numbers in parentheses indicate an item illustrated on pages A-8 – 11.

PARTS AND SERVICE

Repairs, when required, should be performed by your Authorized Nilsk-Advance Service Center, who employs factory trained serv ice personnel, and maintains an inventory of Nilsk-Advance original replacement parts and accessories.

Call the NILFISK-ADVANCE INDUSTRIAL DEALER named below for repairs or service. Please specify the Model and Serial Number when discussing your machine.

(Dealer, afx service sticker here.)

NAMEPLATE

The Model Number and Serial Number of your machine are shown on the Nameplate, located on the wall of the operator’s compartment. This information is needed when ordering repair parts for the machine. Use the space below to note the Model Number and Serial Number of your machine for future reference.

MODEL ________________________________________________

SERIAL NUMBER ________________________________________

Note: Reference the separately supplied engine manufacture’s maintenance and operator manual for more detailed engine specica tion and service data.

UN-CRATING

Upon delivery, carefully inspect the shipping crate and the machine for damage. If damage is evident, save all parts of the shipping crate so that they can be inspected by the trucking company that delivered the machine. Contact the trucking company immediately to l e a freight damage claim.

1After removing the crate, remove the wooden blocks next to the wheels.

2 Check the engine oil and coolant levels.

3 Check the hydraulic oil level.

4 Read the instructions in the Preparing the Machine For Use section of this manual, then ll the fuel tank.

6 Place a ramp next to the front end of the pallet.

7 Read the instructions in the Operating Controls and Operating the Machine sections of this manual and start the engine. Slowly drive the machine forward down the ramp to the oor. Keep your foot lightly on the brake pedal until the machine is off the pallet.

CAUTION!

Use extreme CAUTION when operating this machine. Be certain that you are thoroughly familiar with all operating instructions before using this machine. If you have any questions, contact your supervisor or your local Nilsk-Advance Industrial Dealer. If the machine malfunctions, do not try to correct the problem unless your supervisor directs you to do so. Have a qualied company mechanic or an authorized Nilsk-Advance Dealer service person make any necessary corrections to the equipment. Use extreme care when working on this machine. Loose clothing, long hair, and jewelry can get caught in moving parts. Turn the Key Ignition Switch OFF and remove the key before servicing the machine. Use good common sense, practice good safety habits and pay attention to the yellow decals on this machine.

Drive the machine slowly on inclines. Use the Brake Pedal (FF) to control machine speed while descending inclines. DO NOT turn the machine on an incline; drive straight up or down.

The maximum rated incline for sweeping and scrubbing is 6°. The maximum rated incline during transport is 8°.

A-4- FORM NO. 56041580 - Captor™ 4300, 4800, 5400 / CR 1100, 1200, 1400