Nilfisk-ALTO SR 1301 P Panel Dust Filter Cleaning And Integrity Check, English, User Manual

ENGLISH

USER MANUAL

PANEL DUST FILTER CLEANING AND INTEGRITY CHECK

NOTE

Besides the standard paper filter, polyester filters are also available. The following procedure is applicable to each type of filter.

1.Drive the machine on a level floor and engage the parking brake with the pedal (82) and the lever (75).

2.Turn the ignition key (69) to “0”.

3.Open the hood (23) and fasten it with the support rod (55).

4.Disconnect the vacuum system motor connector (26).

5.Release the fasteners (A, Fig. 12) and remove the vacuum system cover (B).

6.Disconnect the connector (A, Fig. 13) from the filter shaker.

7.Unscrew the knobs (B, Fig. 13) and remove the filter mounting frame (C).

8.Remove the dust filter (D, Fig. 13).

9.In an outdoor area, clean the filter by shaking it on a level and clean surface, tapping the side (A, Fig. 14) opposite to the wire gauze (B).

Complete the cleaning procedure by using compressed air (C) at maximum 6 Bar, blowing only from the side protected by the wire gauze (B), at a minimum distance of 30 cm.

Check the filter body for tears.

According to the filter type, observe the following cautions:

•Paper filter (standard): Do not use water or detergents to clean it, otherwise it can be damaged.

•Polyester filter (optional): For a better cleaning, it is allowed to wash the filter with water and non-lathering detergents. This provides better quality cleaning but reduces the life of the filter, which will have to be replaced more frequently. The use of inadequate detergents can damage the filter.

10.If necessary, clean the filter compartment rubber gasket (A, Fig. 15) along its perimeter and check it for integrity. If necessary, replace it.

11.Assemble the components in the reverse order of disassembly, and note the following:

•Install the filter with the wire gauze (B, Fig. 14) facing upwards.

A

A	B	A
		P100225	P100226
	Figure 12		Figure 13

P100227	P100228
Figure 14	Figure 15

24

1463388000(1)2008-05 A

SR 1301 P