Nissan Z33-D owner manual Programming HomeLink, 44Instruments and controls

￿Your vehicle’s engine should be turned off while programming the HomeLinkUniversal Transceiver.

PROGRAMMING HomeLink

To program your HomeLinkTransceiver to op- erate a garage door, gate, or entry door opener, home or office lighting, you need to be at the same location as the device. Note: Garage door openers (manufactured after 1996) have “rolling code protection”. To program a garage door opener equipped with “rolling code protection”; you will need to use a ladder to get up to the garage door opener motor to be able to access the training button.

2-44Instruments and controls

SIC3012

1.To begin, press and hold the 2 outer HomeLink buttons (to clear the memory) until the indicator light ￿A blinks (after 20 seconds). Release both buttons.

2.Position the end of the hand-held transmitter 1 - 3 in (26 - 76 mm) away from the HomeLinksurface.

SIC3011

3.Using both hands, simultaneously press and hold both the HomeLinkbutton you want to program and the hand-held transmitter but- ton.

DO NOT release the buttons until step 4 has been completed.

4.Hold down both buttons until the indicator light on the HomeLink flashes, changing from a “slow blink” to a “rapid blink”. When the indicator light flashes rapidly, both but- tons may be released. The rapidly flashing light indicates successful programming. To activate the garage door or other pro- grammed device, press and hold the pro- grammed HomeLink button - releasing