Nissan Z33-D owner manual Programming HomeLink for Canadian Customers, Operating the HomeLink

when the device begins to activate.

5.If the indicator light on the HomeLinkblinks rapidly for two seconds and then turns solid, HomeLink has picked up a “rolling code” garage door opener signal. You will need to proceed with the next steps to train the HomeLink to complete the programming which may require a ladder and another person for convenience.

6.Press and release the training button located on the garage door opener’s motor to acti- vate the “training mode”. This button is usu- ally located near the antenna wire that hangs down from the motor. If the wire originates from under a light lens, you will need to remove the lens to access the training button.

NOTE:

Once you have pressed and released the training button on the garage door open- er’s motor and the “training light” is lit, you have 30 seconds in which to perform step

7.Use the help of a second person for convenience to assist when performing this step.

7.Quickly within 30 seconds of pressing and releasing the garage door opener program button, firmly press and release the HomeLinkbutton you’ve just programmed.

Press and release the HomeLinkbutton up to three times to complete the training.

8.Your HomeLinkbutton should now be pro- grammed.

To program the remaining HomeLinkbuttons for additional door or gate openers, follow steps 2-8 only.

NOTE:

Do not repeat step 1 unless you want to “clear” all previously programmed HomeLinkbuttons.

If you have any questions or are having difficulty programming your HomeLinkbuttons, refer to the HomeLinkweb site at: www.homelink.com or call 1-800-355-3515.

PROGRAMMING HomeLink FOR CANADIAN CUSTOMERS

Prior to 1992, D.O.C. regulations required hand- held transmitters to stop transmitting after 2 seconds. To program your hand-held transmitter to HomeLink , continue to press and hold the HomeLink button (note steps 2 through 4 under “Programming HomeLink ”) while you press and re-press (“cycle”) your hand-held transmitter every 2 seconds until the indicator light flashes rapidly (indicating successful pro- gramming).

NOTE:

When programming a garage door opener, etc., it is advised to unplug the device during the “cycling” process to prevent possible damage to the garage door opener components.

OPERATING THE HomeLink

UNIVERSAL TRANSCEIVER

The HomeLink Universal Transceiver (once programmed) may now be used to activate the garage door, etc. To operate, simply press the appropriate programmed HomeLink Universal Transceiver button. The red indicator light will illuminate while the signal is being transmitted.

PROGRAMMING

TROUBLE-DIAGNOSIS

If the HomeLink does not quickly learn the hand-held transmitter information:

￿replace the hand-held transmitter batteries with new batteries.

￿position the hand-held transmitter with its battery area facing away from the HomeLink surface.

￿press and hold both the HomeLink and hand-held transmitter buttons without inter- ruption.

Instruments and controls 2-45