Nissan Z33-D owner manual Seek tuning, Disp SAT radio display change if so equipped

change from stereo to monaural reception.

If the satellite radio signal is lost due to interfer- ence while driving, in a parking structure or tunnel for example, “NO SIGNAL” will be dis- played and no satellite radio station will be available.

TUNE (Tuning):

WARNING

The radio should not be tuned while driving so full attention may be given to vehicle operation.

Push the TUNE button or for manual tuning. To move quickly through the channels, push and hold either side of the TUNE button down for more than 0.5 seconds.

SEEK tuning:

(For FM and AM radio)

Push the SEEK button or to tune from high to low or low to high frequencies and stops at the next broadcasting station.

(For satellite radio)

Push the SEEK button or to seek

channels of the next or previous category.

SCAN tuning:

Push the SCAN tuning button to tune from low to high frequencies and stops at each broad- casting station for 5 seconds. Pushing the but- ton again during this 5 second period will stop SCAN tuning and the radio will remain tuned to that station.

If the SCAN tuning button is not pushed within 5 seconds, SCAN tuning moves to the next sta- tion.

DISP SAT radio display change (if so equipped):

￿Pushing the DISP button will display addi- tional information (for example: Title, Artist name) about the satellite radio broadcast.

￿Pushing the DISP button for more than 1.5 seconds will change the display mode as follows:

Channel number →	Channel name → Artist
name → Song title →	Channel number

Station memory operations:

Twelve stations/channels can be set for the FM band (6 for FM1, 6 for FM2) and the SAT radio (6 for SAT1, 6 for SAT2), and 6 stations can be set for the AM band.

1.Tune to the desired station/channel using the SEEK, SCAN or TUNE button.

2.Select the desired station/channel and keep pushing any of the desired station/channel and preset buttons (1 to 6) until a beep sound is heard. (The radio mutes when the station and preset button is pushed.)

3.The channel indicator will then come on and the sound will resume. Memorizing is now complete.

4.Other buttons can be set in the same manner.

If the battery cable is disconnected, or if the fuse blows, the radio memory will be erased. In that case, reset the desired sta- tions.

Radio data system (RDS):

RDS stands for Radio Data System, and is a data information service transmitted by some radio stations on the FM band (not AM band) and/or SAT encoded within a regular radio broadcast. Currently, most RDS stations are in large cities, but many stations are now consid- ering broadcasting RDS data.

RDS can display:

￿Station call sign, such as “WHFR 98.3”.

￿Station name, such as “The Groove”.

Display screen, heater, air conditioner and audio systems 4-25