NordicTrack CTL8750 8Whenkey.the program is completed, remove, Select the fitness test program

Each pulse-driven program is divided into one-

minute segments. ( The main display will show both the time remaining in the program and the time re- maining in the current segment of the program.)

One target heart rate setting is programmed for

each segment. (During the MANUAL PULSE pro- gram, the same target heart rate setting will be programmed for all segments.)

When only three seconds remain in the first seg- ment of the program, a series of tones will sound and then the speed and/or incline of the treadmill will change, if needed, to bring your heart rate closer to the target heart rate setting for the next segment. The speed and/or incline setting will flash in the main display to alert you before the speed and/or incline changes. The program will continue until no time remains in the program. The walking belt will then slow to a stop.

	If the speed and incline setting for the current seg-
	ment is too high or too low, you can adjust the set-
	ting with the SPEED or INCLINE buttons.
	However, if you		decrease	the speed, the incline
	will automatically		increase	; if you		increase	the
	speed, the incline will		decrease		. If you increase
	the incline, the speed will			decrease		; if you	de-
	crease	the incline, the speed will				increase	. The
	treadmill will always attempt to keep your heart
	rate near the target heart rate setting for the cur-
	rent segment.		Note: When the incline reaches the
	lowest setting, the speed cannot be increased any
	further. When the incline reaches the highest set-
	ting, the speed cannot be decreased any further.
	If your pulse is not detected during the program,
	the letters PLS will flash in the main display and
	the speed and incline of the treadmill may auto-
	matically decrease until your pulse is detected. If
	this occurs, refer to the instructions included with
	your chest pulse sensor.
	To stop the program at any time, press the STOP
	button. Pulse-driven programs should not be
	stopped temporarily and then restarted. To use a
	pulse-driven program again, reselect the program
	and start it at the beginning.
	Follow your progress with the main display.
7
	Refer to step 5 on page 15.

8Whenkey.the program is completed, remove the

Refer to step 6 on page 18.

HOW TO USE THE FITNESS TEST PROGRAM

The fitness test program measures your relative fitness level. For the best results, the program should be used at a time when your energy level is high; the program should not be used if you have already exercised dur- ing the day. Follow the steps below to use the program.

1	Put on a Polar	®-compatible chest pulse sensor
	(not included).

You must wear a chest pulse sensor to use the fitness test program.

2 Insert the key into the console.

Refer to GETTING STARTED on page 14.

3 Select the fitness test program.

When the key is inserted, the manual mode will be selected. To select the fitness test program, press the MODE button repeatedly until the words FIT- NESS TEST appear in the main display.

When the fitness test program is selected, the words FITNESS TEST will scroll across the main display. The words ENTER AGE and the current age setting will then be shown.

During the fitness test

program, the matrix will show a moving graphic that repre- sents your heart rate. Each time a heart- beat is detected, an

additional peak will appear in the graphic.

4 Enter your age.

Your must enter your age to use the fitness

test program. To enter your age, refer to step 4 on page 19.

20