HOW TO | S ET | U P THE | T READMILL |
Assembly requires two persons. | Set the treadmill in a cleared area and remove all packing materials. Do not | ||
dispose of the packing materials until assembly is completed. | Assembly can be completed using the included | ||
allen wrenches. |
|
|
|
Note: The underside of the treadmill walking belt is coated with
1. Slide the Right and Left Uprights (95, 97) onto the brack-
ets near the front of the Frame (76). | Make sure that the |
Uprights are on the correct sides; the indicated holes |
|
must be facing the treadmill. |
|
Raise the Right Upright (95) until the lower hole in the front of the Upright is aligned with the upper hole in the bracket. Thread an Upright Bolt (96) into the Upright and
the bracket. Do not fully tighten the Upright Bolt yet.
Repeat this step with the Left Upright (97).
2.While a second person holds the Handrail (91) near the Uprights (95, 97), feed the wires in both sides of the Handrail down into the Uprights. Pull the ends of the wires out of the lower ends of the Uprights. If there are wire ties on the ends of the wires, remove them.
Finger tighten four Handrail Bolts (99) into the Uprights
(95, 97) and the Handrail (91). Do not tighten the
Handrail Bolts yet. Be careful to avoid pinching the wires.
Note: The CD Holder (86) and the Cup Holder (85) are replaceable. If these parts become dislodged from the Console Base (89), simply press them back into place.
3.Connect the Network Wire (18), the TV Cable (17), the Network Wire Harness (59), and the Right Power Wire Harness (57) in the indicated locations. Push all of the
excess wire up into the Uprights (95, 97). | Make sure |
that all wires are fully connected. Note: Regardless |
|
of which console your treadmill has, connect all |
|
wires so that the console can later be upgraded if de- |
|
sired. |
|
1 | Holes | 95 |
|
| |
|
| 96 |
97 |
|
|
| 96 |
|
|
| 76 |
2 |
|
|
|
| 89 |
| 86 |
|
91 |
|
|
| 99 | 85 |
97 |
|
|
| Wires | 95 |
3 |
| 95 |
97 |
| |
|
| |
18 | 17 | 57 |
| 59 |
7
