NordicTrack NTB49030 user manual Make sure the Cable is routed under the bolts

41. Route the Low Cable (55) around a 3 1/2” Pulley	41
(45) and through the bracket on the Base (1).
			74
Attach the Pulley inside the bracket with an M10
x 48mm Button Bolt (74) and an M10 Nylon			1
Locknut (62).
			55
			45
			62
42. Route the Low Cable (55) around a 3 1/2” Pulley	42	74
(45) and through the bracket on the Base (1).
Make sure the Cable is routed under the bolts
in the Base. Attach the Pulley inside the bracket
with an M10 x 48mm Button Bolt (74) and an M10			Cable Path
Nylon Locknut (62).
			45
		62
43. Wrap the Low Cable (55) under a 3 1/2” Pulley	43
(45). Attach the Pulley inside the Base (1) with			55
		45
the M10 x 178mm Button Bolt (78) and the M10
			49
Washer (65) used in step 26, and a 12mm
Spacer (49). Make sure the 3 1/2” Pulley (45)			1
attached in step 26 is reattached to the Base
as shown in step 26.
		65
		45	78
44. Wrap the Low Cable (55) over a 3 1/2” Pulley	44
(45). Attach the Pulley and a Short Cable Trap			73
(47) at the bottom hole in the indicated “U”-brack-		19
et (19) with an M10 x 54mm Button Bolt (73) and		62
an M10 Nylon Locknut (62). Make sure the
Cable Trap is oriented to hold the Cable in the			45
groove of the Pulley.
		47	55
45. Route the Low Cable (55) through the Base (1) in	45
the manner shown in step 42. Make sure the
		49	45
Cable is routed under the bolts in the Base
(1).		62
		65
Hold a 3 1/2” Pulley (45) over the Low Cable (55).
Attach the Pulley inside the Base (1) with the
M10 x 178mm Button Bolt (78) used in step 43, a
12mm Spacer (49), an M10 Washer (65), and an		55
M10 Nylon Locknut (62).
			78
			1

16