10.Grease an M10 x 112mm Bolt (76) and the Right Butterfly Arm (8) in the indicated locations. Attach the Arm to the Center Upright (3) with the Bolt, an M10 Nylon Locknut (62), and two Butterfly Bolt Caps (52). Do not overtighten the Locknut; the
Butterfly Arm must be able to pivot easily.
Repeat this step with the Left Butterfly Arm
(9).
11.During steps
Locate the Carriage Cable (56). Insert an M8 x 19mm Shoulder Bolt (80) through the eyelet on the Cable and the Weight Carriage (12). Tighten an M8 Nylon Locknut (82) onto the Bolt.
12.Wrap the Carriage Cable (56) over a 3 1/2” Pulley
(45).Attach the Pulley to the Center Top Frame
(2)with an M10 x 192mm Button Bolt (64) and an M10 Nylon Locknut (62).
13.Wrap the Carriage Cable (56) under a 3 1/2” Pulley (45). Attach the Pulley and a Short Cable Trap (47) at the second set of holes from the top of the two Pulley Plates (20) with an M10 x 54mm Button Bolt (73) and an M10 Nylon Locknut (62).
Make sure the Cable Trap is oriented to hold the Cable in the groove of the Pulley.
10 |
|
|
Grease | 52 |
|
| 76 |
|
8 |
|
|
62 | 3 |
|
|
| |
Grease 52 |
|
|
| 9 |
|
11 |
|
|
| 82 | 56 |
|
| 80 12 |
12 |
|
|
| 45 | 2 |
56 |
| |
|
| |
62 |
|
|
|
| 64 |
13 |
|
|
| 56 |
|
| 45 |
|
62 |
| 73 |
|
| |
| 47 |
|
20 |
|
|
| 20 |
|
9
