51.Attach the Backrest (60) to the Center Upright (3) with two M6 x 70mm Screws (69) and two M6 Washers (66).
52.Identify the Right Butterfly Pad (58) (see the inset drawing). Attach the Pad to the Right Butterfly Arm (8) with two M6 x 63mm Button Bolts (68) and two M6 Washers (66).
Attach the Left Butterfly Pad (59) to the Left Butterfly Arm (9) in the same manner.
53.Locate the Weight Rest (15) with the Right Weight Rest Hook (17) attached to it. Set the hooks on the Weight Rest over a set of knobs on the Right Upright (5).
Repeat this step with the other Weight Rest (not shown). Always set both Weight Rests (15) at the same height.
51 |
|
|
|
|
|
| 69 |
|
|
| 66 |
| 60 |
|
|
52 |
|
|
|
| 8 |
|
|
68 | 66 | 58 |
|
|
| 9 | |
|
|
| |
58 |
| 59 |
|
53 |
|
|
|
| 15 |
| 5 |
| 17 |
|
|
54.Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in ADJUSTMENTS, beginning on the following page.
Before using the weight rack, pull each cable a few times to make sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE DIAGRAMS on pages 21 and 22 of this manual for proper cable routing. If there is any slack in the cables, you will need to remove the slack by tightening the cables. See TROUBLESHOOTING AND MAINTENANCE on page 23.
18
