16.Press two Large Handgrips (31) onto the two Butterfly Handles (11). Press four Butterfly Arm Bushings (64), and two 35mm Round Inner Caps (39), into the Butterfly Handles.
Identify the Left and Right Butterfly Arms (6, 7) by the location of the rods.
Slide a Handle (11) onto the Left Butterfly Arm
(6). Place two 1” Retainers (44) under a Round Cover Cap (45), as shown in the inset drawing.
Be sure the teeth on the Retainers bend toward the Cover Cap. Tap the Cover Cap and Retainers onto the Left Butterfly Arm.
Attach the other Handle (11) to the Right Butterfly Arm (7) in the same manner.
17.Press two Butterfly Arm Bushings (64) into the Seat Frame (3).
Attach the Left Butterfly Arm (6) to the Seat Frame (3) with a 38mm Washer (81) and an M10 x 25mm Bolt (82). Make sure the rod on the
Butterfly Arm is behind the Seat Frame.
Repeat this step with the Right Butterfly Arm
(7).
18.Press a 50mm Square Inner Cap (72) into the top of the Leg Lever (4).
Attach a Bumper (51) to the Seat Frame (3) with an M4 x 20mm
Lubricate an M10 x 75mm Bolt (99) with grease. Attach the Leg Lever (4) to the Seat Frame (3) with the Bolt and an M10 Nylon Locknut (93). Do not overtighten the Locknut; the Leg Lever must be able to pivot easily.
16 |
|
|
|
| 39 |
45 |
|
| 39 | 45 | 31 |
|
|
| 31 | 44 |
|
44 |
|
| 11 |
| 11 |
|
| 64 |
| ||
|
|
|
| ||
| 7 | 6 |
|
| |
|
|
|
|
| |
|
| Rod |
|
| |
17 |
|
|
|
|
|
|
| 7 |
|
|
|
Rod |
|
| 6 |
|
|
|
|
|
|
| |
|
|
| 64 |
|
|
|
|
| 3 |
|
|
| 81 |
| 64 |
|
|
|
|
|
|
| |
|
|
| 82 |
|
|
18 |
|
|
|
|
|
|
| 72 | 3 |
|
|
|
|
|
|
| |
93 |
|
| 99 24 |
|
|
|
|
|
|
| |
|
|
| 65 | 51 |
|
4 |
|
|
|
| |
|
|
|
|
| |
11
