NordicTrack NTSY59210 user manual

35.Insert a 115mm Pulley (54) into the Leg Lever (4). Route the High Cable (100) under the Pulley. Attach the Pulley inside the Leg Lever with an M10 x 65mm Bolt (88), two M10 Washers (89), two 15mm x 12mm Spacers (62), and an M10 Nylon Locknut (93).

Slide a Cable Ball (78) onto the end of the High Cable (100). Thread the M10 Nut (25) all the way onto the Cable Eye (22). Tighten the Cable Eye into the end of the Cable. Tighten the M10 Nut against the Cable Ball.

Press a 50mm Square Inner Cap (72) into the bottom of the Leg Lever (4).

36.Locate the Butterfly Cable (102). Attach one end of the Cable to the Left Butterfly Arm (6) with an M10 x 40mm Bolt (83), a 15mm x 12mm Spacer (62), an M10 Washer (89), and an M10 Nylon Locknut (93). Make sure the Spacer is inside the loop in the Cable.

37.Wrap the Butterfly Cable (102) around a 115mm Pulley (54). Attach the Pulley and a Cable Trap

(52)to the indicated bracket on the Press Base

(1)with an M10 x 45mm Bolt (86) and an M10 Nylon Locknut (93). Be sure the Cable Trap is turned to hold the Cable in the groove of the Pulley.

38.Wrap the Butterfly Cable (102) around a 115mm Pulley (54). Attach the Pulley to the bottom of the Double “U”-bracket (36) with an M10 x 45mm Bolt (86) and an M10 Nylon Locknut (93).

35
	4
89	62
93
100
78		62
			88
25	72	89
22		54
36
	93
	6		89
		62	83
		102
37
			52
			86
		93 54
		1
	102
38
	36	86
	93
		54
		102

16