50.Press four 19mm Round Inner Caps (70) into the ends of the two Short Pad Tubes (38).
Slide a Short Pad Tube (38) through the hole in the Leg Lever (4). Slide two Foam Pads (43) onto the ends of the Pad Tube.
Slide a Short Pad Tube (38) through the hole in the Seat Frame (3). Slide two Foam Pads (43) onto the ends of the Pad Tube.
51.Attach the Seat (49) to the Seat Bracket (5) with four M6 x 16mm Screws (85). Note: The Seat
Bracket will be closer to the rear edge of the Seat.
52.Screw the Seat Knob (98) into the Seat Frame
(3).
Pull the Seat Knob (98) out as far as it will go. Slide the Seat Bracket (5) into the Seat Frame (3) and engage the Knob into an adjustment hole in the Seat Bracket. Tighten the Knob.
53.Press two 25mm x 50mm Inner Caps (69) into the Backrest Frame (14). Attach a 38mm Bumper
(48)and the 25mm Bumper (60) to the Backrest Frame with two M4 x 20mm
(65)and two M4 Washers (24).
Slide the adjustment arm on the Backrest Frame
(14)through the bracket on the Press Upright
(16).Tighten the Pin w/Knob (58) into the Press Upright and engage the adjustment arm.
Attach the Backrest Frame (14) to the Press Upright (16) with an M10 x 80mm Bolt (92) and an M10 Nylon Locknut (93).
50 |
|
| 43 |
|
|
|
|
| |
|
| 70 |
| 3 |
|
|
|
| |
|
|
| 38 |
|
|
| 43 | 70 |
|
|
|
| 4 | 43 |
|
|
|
| |
51 |
| 49 |
| Rear |
|
|
| ||
|
|
|
| Edge |
|
|
|
| 85 |
|
|
| 5 |
|
|
| 85 |
|
|
52 |
|
|
|
|
|
| 5 |
|
|
|
| 3 |
|
|
|
|
| 98 |
|
53 |
|
|
|
|
| 69 |
|
| |
|
| 16 |
|
|
| 14 |
|
| |
24 | 48 | 58 | 65 | |
|
|
| 60 | |
|
|
|
| 14 |
65 | 92 | 24 | ||
69 | 93 |
| ||
20
