Frame Assembly
1.
Before beginning, read the information on page 5. This brief introduction will save you much more time than it takes to read it.
Press three 50mm Square Inner Caps (72) into the Press Base (1).
Insert four M10 x 67mm Carriage Bolts (87) and two M10 x 72mm Carriage Bolts (73) up through the bottom of the Press Base (1). Place the Press Base flat on the floor. Note: If the Bolts fall out, place a piece of tape over the bolt heads to hold them in.
2.Press two 50mm Square Inner Caps (72) into the extensions on the Rear Base (2). Press a 50mm x 75mm Inner Cap w/ Slot (95) into the end of the Rear Base. Insert four M10 x 67mm Carriage Bolts (87) up through the bottom of the Rear Base.
Slide the Rear Base (2) onto the two M10 x 72mm Carriage Bolts (73) in the Press Base (1). Attach the Rear Base to the Press Base with two M10 x 70mm Bolts (79), two M10 Washers (89), and two M10 Nylon Locknuts (93). Do not tight- en the Locknuts yet.
Note: If you have purchased the hack squat extension (model NTSY3921), do not insert the four M10 x 67mm Carriage Bolts (87) or the 50mm x 75mm Inner Cap w/ Slot (95) into the Rear Base (2). Instead, complete step 2 in the NTSY3921 manual.
3.Attach the Right Upright (17) to the two M10 x 72mm Carriage Bolts (73) in the Press Base (1) and Rear Base (2) with two M10 Nylon Locknuts (93). Do not tighten the Locknuts yet. Make sure the rod is on the indicated side of the Upright.
1 |
| 72 |
|
|
|
| |
|
| 1 | 72 |
|
|
| 73 |
|
| 87 |
|
|
| 87 |
|
| 72 |
|
|
2 |
|
|
|
|
| 79 |
|
|
|
| 72 |
| 93 | 89 |
|
|
|
| |
| 89 |
|
|
|
|
| 2 |
| 1 | 73 | 95 |
|
| ||
|
|
| 87 |
3 |
|
|
|
|
| Rod |
|
|
| 17 |
|
|
| 93 |
|
|
| 93 |
|
|
| 73 |
|
| 1 | 2 |
|
|
|
|
6
