NordicTrack NTSY59210 user manual Tighten the M10 Nylon Locknuts 93 used in steps

9.See the inset drawings. Press the two Top Weight Bushings (33) into the Top Weight (32). Press two 5-pound Weight Bushings (104) into each 5-pound Weight (34). Press two 10-pound Weight Bushings (61) into each 10-pound Weight (29).

Slide a Weight Bumper (28) onto each Weight Guide (27). Slide the sixteen 10-pound Weights (29), the seven 5-pound Weights (34), and the Top Weight (32) onto the Weights Guides in the order shown.

10.Press a 50mm Square Inner Cap (72) into the extension on the Rear Top Frame (19). Press two Weight Guide Bushings (57) into the Rear Top Frame.

Set the Rear Top Frame (19) onto the two Weight Guides (27).

Attach the Rear Top Frame (19) to the Press Top Frame (13) with two M10 x 70mm Bolts (79), two M10 Washers (89), and two M10 Nylon Locknuts (93).

Attach the Rear Top Frame (19) to the Left Upright (20) with two M10 x 45mm Bolts (86), two M10 Washers (89), and two M10 Nylon Locknuts (93). Note: If you have purchased the hack squat extension (model NTSY3921), do not use the two M10 x 45mm Bolts (86) and two M10 Washers (89). Instead, complete steps 3–8 in the NTSY3921 manual.

Do not tighten the M10 Nylon Locknuts (93) yet.

11.Slide two M8 x 90mm Bolts (90) through two M8 Large Washers (53), two 15mm x 30mm Spacers (23), the Rear Top Frame (19), the Weight Guides (27), and two more 15mm x 30mm Spacers.

Tighten the M10 Nylon Locknuts (93) used in steps 2–10.

9
		27
		32
		34
			29
		28	28
	33
	104	61
	32
	34	29
10	19
		93	72
	79	93	93
	89		93
		13	57
			89
		27
			86
			20
11		53	90
		19 23
			53
		23
	23	27

9