Chapter 3 Instant Internet 400 hardware installation 37
2Attach one end of the communications cable (modem, ISDN, T1, DDS, Ethernet, token ring) to the appropriate connector on the Instant Internet unit.
3Attach the other end of the communications cable to the appropriate source (phone jack, ISDN jack, T1 jack, DDS jack, cable modem, or external router).
4Attach the Instant Internet unit to a hub on your LAN using an Ethernet cable (attach to Eth1) or a token ring cable (attach to Tok1).
Note: A token ring cable is not included with your Instant Internet package.
5Plug the power cord into the rear panel of the Instant Internet unit.
6Plug the power cord into an AC wall outlet.
7Turn on the Instant Internet unit.
When you turn on your Instant Internet 400 unit, the LEDs on the front panel illuminate. LED #2 glows amber when the unit is ready for setup. For information about setting up your unit, see Installing the BayStack Instant Internet Management Software Version 7.11
Mounting your Instant Internet unit in a rack
To install your Instant Internet in an equipment rack, you will need a Phillips screwdriver (not included) and the brackets, screws, and washers provided in the rack mounting kit.
To mount your Instant Internet 400 in a rack:
1Remove the three screws from the cover on each side of your Instant Internet unit as shown in Figure 3.
