24First time installation of the IP Phone 1535
Physically install the IP Phone 1535
Basic installationof the IP Phone 1535 consists of connecting to the correct ports using the appropriate cables. Make the physical connections for the handset and power, as well as attach the IP Phone 1535 to the included telephone stand, by following the procedures in the following sections.
Installation guidelines
Consider the following conditions when you choose a location in which to install the IP Phone 1535:
• Use the IP Phone 1535 in an environment with a temperature range of +0 to 40 C and a relative humidity of 5 to 95 percent.
• Place the IP Phone 1535 on a smooth, nonslip surface.
• Do not install the IP Phone 1535 in a dusty environment; dust deposits can adversely affect moving parts.
• Do not install the IP Phone 1535 in a location directly exposed to sunlight or radiant heat sources; these can cause damage to electrical components.
• The IP Phone 1535 does not support Power Over Ethernet (PoE); therefore, do not install the phone on a PoE configuration.
Connect the handset
Step Action
1Insert one end of the coiled cord into the handset connector port. This port is on the handset cradle side of the IP Phone 1535.
2Insert the other end of the coil cord into the port on the handset.
—End—
Connect the IP Phone 1535 to a power source
WARNING
Use only the power adapter supplied with the IP Phone 1535, as other adapters can cause operating anomalies, hazardous conditions, and material damage.
Step Action
1Insert the power adapter DC plug into the DC power jack, at the rear of the IP Phone 1535 phone base.
Nortel Communications Servers
Nortel IP Phone 1535 Installation and Commissioning
Release 4.0/SN10 28 October 2009
Copyright © 2009, Nortel Networks
